Ammonium Metatungstate Prepares Tungsten Copper EFP Liner
By comparison, tungsten copper W-Cu system combines high hardness, high density, high strength and excellent chemical properties of W and excellent thermal conductivity of and plasticity of Cu. Since there is a big difference between W and Cu (W-3410℃,Cu-1083℃), After the explosion of copper is evaporated leaving a high hardness, high density hard phase tungsten, compared to copper Liner armor penetration depth can be increased by nearly 30%. Therefore, tungsten copper EFP liner has a broad application prospect in the future. Ordinary tungsten powder, copper powder and ultra-fine tungsten-copper composite powder prepared tungsten copper EFP Liner and its performance was compared. Wherein ultrafine tungsten copper composite powder is prepared by using spray pyrolysis, it uses a proportion of copper nitrate and ammonium metatungstate dissolved in distilled water into the mixed solution, and then the pressure centrifugal spray drier precursor powders, the precursor powder is then placed in roasting reduction furnace. Finally, wet ground and placed in a ball mill reduction in the reduction furnace, ultra-fine tungsten-copper composite powder particle size is formed between 100-300nm. 
After the tungsten copper rod made of tungsten copper EFP started liner blank forging, which blank deformation has three steps: 1. upsetting the blank in the mold, in this process the blank upper and lower parts deformation occurs first, and upper and lower portions of the pores gradually become less under the influence of compressive stress, density increases, increasing the contact area with the punch, friction force increases, under the action of the metal tensile stress generated lateral flow; 2. metal flows hindered by the mold wall and it will flow along with the hole of the mold bottom, and in the process the pores reduces and the density increases; finally, when the metal flow to the ejector rod will enter the multi-pressure stage, mainly through its hydrostatic pressure to eliminate rough pores, so the effect is not significant.
In addition, in the process of tungsten copper EFP liner blank forging, there are two ways of deformation of the matrix material, one is only copper phase deformation, deformation does not occur with tungsten and tungsten particles along the direction of deformed copper matrix flow was streamlined distribution; the other one is both of Cu and W phase have deformation and form fibrous structure. In order to ensure that the final density, tensile strength and elongation to achieve the desired requirements, we should make a reasonable design for tungsten copper EFP liner shape and have sufficient deformation.
AMT Supplier : Chinatungsten Online - http://ammonium-metatungstate.com
Tel.: 86 592 5129696; Fax: 86 592 5129797 Email: sales@chinatungsten.com
Tungsten & Molybdenum Information Bank: http://i.chinatungsten.com
Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
Molybdenum News & Molybdenum Price: http://news.molybdenum.com.cn
More details of the above news and/or products, please visit Chinatungsten Online, or contact us directly.
Disclaimer: The article is only reflecting the opinions of the author. We have no responsibility to prove the originality and authenticity of the content, words and/or pictures. You readers should just take it as reference and check the details by yourselves. And the content is not a suggestion for investment decision. The investor takes his or her own risks if he or she operates accordingly. If you have any dissent about the contents above, please contact the relevant author, or the webmaster. We will try our best to assist the dealing of the related issues. Thanks for your visit and cooperation.
|
